Updated November 2026. A panel that arrives cracked is a return; a panel you crack while fitting is a purchase. Ten minutes of inspection on arrival is the cheapest insurance in this hobby.

In short:
- Photograph the box before opening it.
- Check edges, fastener holes and the back face, not just the visible weave.
- Test-fit before you remove the original part.
What should you know about before you open the box?
Photograph the packaging as it arrived, including crush marks or corner damage. If a claim is needed, that photo is the first thing anyone asks for. Cut tape rather than pulling it, and keep the packing material until you have inspected the part.
Sending a part back in its original packaging is much easier than finding an equivalent box.
What should you look at on the part?
Edges. Clean and sealed, with no white fibres showing. Fuzzy edges are a finishing issue, not necessarily a defect, but worth noting. Fastener holes. Look for star cracks radiating from a hole. That is impact or over-tightening damage, and it will spread.
- The back face. Any sign of delamination, a white cloudy patch where layers have separated, is a structural problem.
- Weave direction. Real cloth shifts where the mould curves. A pattern that repeats identically across a curve is a printed finish.
- Clearcoat. Small dust nibs are normal on hand-finished parts. A run or a cloudy patch is not.
What should you know about test-fit before removing the original?

Hold the new panel against the bike with the old one still fitted where possible, or lay it on a bench next to the original. Holes should line up without pressure. If it needs force at this stage, stop. Do not fit it, do not drill it, and do not assume it will settle once bolted.
A panel that fights on the bench will crack on the bike.
What is normal, and what is not?
Normal: slight variation in weave appearance between panels, small dust nibs in clearcoat, a marginally different edge finish from the factory part. Not normal: cracks at holes, delamination, a warped panel, or mounting points that do not correspond to the bike.
What should you know about if something is wrong?
Photograph it before fitting anything, keep the packaging, and contact the seller with the photos and your order number. Fitting a damaged panel usually voids the claim, which is why the inspection happens first.

| Dimension | Notes |
|---|---|
| Platform | Not a single-bike fitment note. Confirm the platform on the product page. |
| Part | carbon panels in transit |
| Install | Not a single-part install note. Follow the sections above. |
| Use | Care, fit, or buying judgment. Not a fitment claim for one bike. |
| Shop | https://isleparts.com/collections |
What are the common questions about inspection?
Should I fit it to check? Are dust nibs a defect? What is delamination? Can I repair a crack at a hole?
Should I fit it to check?
Test-fit only, with nothing tightened. A dry fit is not fitting.
Are dust nibs a defect?
No, they are normal on hand-finished carbon.
What is delamination?
Layers separating, visible as a cloudy or white patch. Treat it as structural.
Can I repair a crack at a hole?
Not reliably. It is the highest-stress point on the part.
Fitting sequence: align before you tighten. Material background: dry, wet and carbon look.