Updated November 2026. There are three things sold as "carbon", and only two of them contain carbon fibre. Knowing which one you are looking at decides whether the part is worth the price.
What is the three?
| Dry carbon | Wet carbon | Carbon look | |
|---|---|---|---|
| What it is | pre-preg fibre, cured under heat and pressure | fibre laid by hand, resin applied wet | plastic or film printed with a weave pattern |
| Weight | lightest for the same part | heavier: more resin | same as plastic |
| Consistency | even weave, controlled resin | varies part to part | identical every time |
| Repairable | poorly once cracked | moderately | no: it is plastic |
| Cost | highest | mid | lowest |
How do you tell them apart in person?
Look at the back. Real carbon is fibre all the way through. A carbon-look part is uniform plastic or film on the reverse, often with a mould texture that does not match the front. Look at the weave at an edge. On a real carbon part the weave wraps around the edge or is cut and sealed.
On a printed part the pattern simply stops.
Tap it. Carbon rings thin and hard. Plastic sounds dull. Not conclusive on a mounted part, but useful on a loose one.
Weigh it against the stock part. The single most reliable test: a real dry carbon panel is noticeably lighter than the plastic it replaces. A carbon-look cover is not.
Why dry carbon costs what it does?
Pre-preg material has a shelf life and must be stored cold. Curing needs an autoclave or a heated press, which is capital equipment, and each part is finished by hand. None of that scales down for a small run.
What should you know about wet carbon is not a scam?
It is a legitimate process used on plenty of good parts. It is heavier and less consistent than dry, and it usually costs less. If a listing says wet carbon, the price should reflect it.
What should you know about carbon look is fine if it is sold as that?
A printed cover at a plastic price is an honest product. The problem is only when it is priced or described as carbon fibre. Check the material line before the photo.
What does we?
Our carbon ranges are listed as 3K dry carbon on the product pages where that applies, and finishes are stated where a part is not carbon. We do not upgrade a description because a buyer hoped for a weave. Carbon ranges: ZX-10R, S1000RR.