Updated November 2026. The rear tail side panels the pair are the flanks of the ZX-10R's tail — the surfaces that decide whether a carbon tail reads from the side as well as from behind. Same price as the front fender, different half of the bike.

In short:
- For the pair, left and right.
- They are the flanks: the centre panel is the rear tail panel.
- Full carbon tail — centre, sides, trim, subframe — is.
Where they sit?
On the Kawasaki ZX-10R, use the product cards for current figures. This section keeps the choice, not a copied price. rear tail panel subframe cover
What is the four parts of a ZX-10R carbon tail?
| Part | Where to check the price | What it covers |
|---|---|---|
| Rear tail trim panel | See the product card | the trim strip |
| Subframe cover | See the product card | the structure below |
| Tail side panels | See the product card | the flanks |
| Rear tail panel | See the product card | the centre, seen from behind |
On the Kawasaki ZX-10R, all four together:. Two of them — the side panels and the subframe — cost the same, which is why they are routinely confused; one is the flank you see from three metres, the other is the structure you see when you crouch.
Why the pair?
On the Kawasaki ZX-10R, tail flanks are symmetrical and visible together in every rear three-quarter shot — one side carbon and one side painted reads as damage, not a build. That is why they are sold as a pair and why the pair is the honest unit.
The same logic does not apply to every part in the range: the right small side panel is sold singly for exactly the opposite reason — single-side damage.
What they change, and what they do not?
On the Kawasaki ZX-10R, they change the width of the carbon read at the back: with the centre panel alone, the tail is carbon from directly behind and painted from the sides. They do not add structure, they do not protect in a fall, and they do not change the seat unit.
Carbon cracks where plastic flexes, and the tail flanks sit exactly where a low-speed drop puts load. If the bike is regularly parked on a street, that is worth knowing before spending on two panels.
How do you install the carbon rear tail side panels?
On the Kawasaki ZX-10R, fit after the centre panel, with the seat unit loose so the edges can be aligned together. Aftermarket, not genuine Kawasaki; no torque values published — use your manual. Confirm the year range on the listing.
What are the common questions about tail side panels?
On the Kawasaki ZX-10R, these are the usual questions. Are they the same as the BMW tail side panels? Can I fit them with the stock tail panel? Do they need painting? Are they genuine Kawasaki parts? One side or both?
Are they the same as the BMW tail side panels?
No — different bikes, different moulds, different prices. Nothing crosses brands.
Can I fit them with the stock tail panel?
Physically they cover their own area; visually a carbon flank against a painted centre is the mismatch to avoid.
Do they need painting?
No — they ship in the carbon finish.
Are they genuine Kawasaki parts?
No, aftermarket, as the listing states.
One side or both?
This listing is the pair. A single side is not offered for this panel.
Product page: ZX-10R Carbon Rear Tail Side Panels. Collection: ZX-10R carbon.