Updated November 2026. Bodywork is not crash protection, and buying carbon instead of sliders gets the order backwards. One is designed to absorb and slide; the other is designed to look right and weigh less.

What does each actually in a fall?
| Bodywork (fairing, carbon panels) | Protection (sliders, case covers, guards) | |
|---|---|---|
| Purpose | shape, airflow, appearance | keep the bike off the ground |
| In a fall | cracks or abrades | wears down instead of the frame |
| Reusable | usually not | often yes, until worn through |
| Cost of failure | a panel | a frame, engine casing or lever |
Why is carbon worse at this job, not better?
Carbon is stiff and strong in the direction it was designed for, and brittle when loaded the way a fall loads it. Where ABS deforms and absorbs, dry carbon cracks. A panel that would have been scuffed becomes a panel that needs replacing.
That is not a fault in the material. It is a fault in expecting it to do a job it was not made for.
What actually protects a bike?
- Frame sliders or crash bobbins at the engine mounts: the first point of contact in most low-sides.
- Case covers over the engine casings, which are expensive and easily ground through.
- Lever guards on the brake side, which also matter on track.
- Bar ends and axle sliders, cheap and effective on a low-speed drop.
We sell lever guards and bodywork. We do not sell frame sliders for most of these platforms, and we are not going to suggest a fairing panel as a substitute.

Which order makes sense?
Protection first: whatever sliders and covers exist for your bike. Then the parts you will actually look at: screen, tail, tank cover. Then the expensive panels, once you have stopped dropping it in car parks.
What is the car park problem?
Most damage to bodywork does not happen at speed. It happens at walking pace: a side stand on soft ground, a wet garage floor, a bike rolling off a paddock stand. That is why the first thing to protect is the part that touches down first, not the part that looks best.

What should you know about if you have already dropped it?
Check the mounting points on the frame and subframe before fitting a replacement panel. A panel that will not sit flat afterwards is usually telling you something behind it has moved. Lever guards: 703RR. Bodywork ranges: ZX-10R, S1000RR.