Updated November 2026. Half the paddock brings a full toolbox and uses four things. This is the short list that covers bodywork at a track day, plus the items people forget and end up borrowing.

In short:
- Trim tool, hex and Torx drivers, tape, cable ties, spare clips.
- No power tools for bodywork, ever.
- Bring the manual page with torque figures, or do not touch structural fasteners.
What is the short list?
Trim tool for clips. Fingernails and keys break tabs. Hex and Torx drivers in the sizes your panels use, usually two or three sizes rather than a full set. Small torque wrench if you are touching anything structural. Tape for lights and indicators, in the colour your organiser requires.
- Cable ties, because something always needs holding.
- Spare clips in the sizes your bike uses.
- A soft mat to put panels on. Gravel is the enemy of a painted panel.
What people forget?
Something to store removed panels in. Mirrors, plates and lights come off and then get stacked on a trailer floor. A padded bag or a blanket solves it. A marker and tape for labelling fasteners. Two hours later, nobody remembers which bolt went where.
Cleaning wipes. Track dust plus a dry rag equals scratches on the way home.

What not to bring?
Power drivers. They strip threads and crack panels, and at a track day you are working fast, which is exactly when it happens. Threadlocker on bodywork fasteners. It slows the next removal and is rarely needed for trim. A full socket set if you are only doing bodywork.
- Weight and time.
What is the one structural rule?
If a fastener holds load, a clamp, a fork or a brake component, you need the manual torque figure. Not a guess, not a forum post, not tight plus a bit. Our listings do not publish torque values and this article will not invent them.
If you do not have the figure at the track, leave that fastener alone. Bodywork is a paddock job; structural work is a workshop job.
What should you know about after the day?
Wash the bike before you put it away, then look for the things scrutineering will not catch: a clip that has gone missing, a panel that has moved at one edge, a tab that has cracked. Ten minutes at home beats discovering it at the next event.

| Dimension | Notes |
|---|---|
| Platform | Not a single-bike fitment note. Confirm the platform on the product page. |
| Part | track day packing |
| Install | Not a single-part install note. Follow the sections above. |
| Use | Care, fit, or buying judgment. Not a fitment claim for one bike. |
| Shop | https://isleparts.com/collections |
What are the common questions about packing?
Do I need spare panels? Should I bring touch-up paint? What tape do organisers want? Is a paddock stand enough?
Do I need spare panels?
Only if you have them. Cheap parts are worth carrying if you expect a tip-over.
Should I bring touch-up paint?
For small chips, yes, if you have a matched colour.
What tape do organisers want?
Ask them. Requirements vary, and tape colour is sometimes specified.
Is a paddock stand enough?
For bodywork, usually. For anything that needs the front supported, no.
Related: what to change before a track day.