Updated November 2026. The 820RR aluminium top triple clamp is the steering-assembly part of the range — the upper clamp that anchors the fork tubes and, on most platforms, the step before any clip-on conversion. It is also the one 820RR part where the fitting rules are workshop-grade, because the clamp holds the front end together.

In short:
- Aluminium alloy, Black or Silver.
- The only part in the 820RR range that touches the steering assembly.
- Not a styling part: torque figures and fork support are the job.
What does the top triple clamp change?
On the ZXMOTO 820RR, the top clamp holds both fork tubes at the crown, defines the bar mount height on most bikes, and carries the ignition or bar clamp hardware depending on the platform's layout.
A replacement in aluminium alloy serves two purposes on this bike: a stiffer, cleaner-looking upper clamp, and a base for bars or accessories that mounts to stock points.
| Part | Where to check the price | Touches |
|---|---|---|
| Aluminum top triple clamp | See the product card | fork tubes, steering assembly |
| Raised footpegs | See the product card | body position |
| Fuel cap | See the product card | nothing structural |
Three parts and only one is structural. If you are comparing by price, do not compare by price.
What is the fork-height step?
On the ZXMOTO 820RR, on many bikes, changing the top clamp is when fork height gets adjusted — the tubes sit in the clamp at a set height, and a few millimetres up or down changes steering geometry.
The listing for this part does not publish a fork-height specification, so the honest position is: refit the tubes at the original height marking, measure both sides, and change nothing you cannot verify.
If you want a geometry change, that is a decision to make deliberately with the manual open, not a side effect of a part swap.
How do you fit rules, plainly?
- Support the front end so the fork tubes cannot drop when the clamp is loosened.
- Loosen and retighten in the sequence your manual gives; a clamp tightened unevenly pinches one tube.
- Torque to the manual's figures. There is no safe guess for a steering clamp.
- Check bar and cable sweep at full lock before the first ride.
This is the one ZXMOTO 820RR part where we will say plainly: if you do not have the manual figures or the tools, pay a workshop. The part is; a front end that lets go at speed is not priced.
Where does it sit in the range?
On the ZXMOTO 820RR, late, and by complaint. Unlike the windshield, it does not change the ride until it is fitted correctly and deliberately. It belongs in a build after the parts you see and use — screen, hanger, cowl — and only if the cockpit is the actual goal.
What are the common questions about top clamp?
On the ZXMOTO 820RR, these are the usual questions. Does it include clip-ons? Do I need to remove the front wheel? Is it anodised? Are these genuine ZXMOTO parts? Can I change fork height with it?
Does it include clip-ons?
No — this listing is the clamp alone. The 450SR and 703RR ranges have clamp-plus-clip-on listings; the 820RR does not.
Do I need to remove the front wheel?
No, but you do need the front end supported. A paddock stand under the frame plus a second support under the forks is the setup.
Is it anodised?
The listing states aluminium alloy in Black or Silver. Check the product page for finish detail.
Are these genuine ZXMOTO parts?
No, aftermarket, as the listing states.
Can I change fork height with it?
Not as a feature. Refit at the original height and only change it deliberately, with the manual.
Product page: ZXMOTO 820RR Aluminum Top Triple Clamp. Collection: ZXMOTO 820RR parts.