Updated November 2026. Seven holes is not a marketing number. On the ZONTES 703RR adjustable rearsets it is seven possible places to bolt the footpeg, and each one changes where your leg sits, how much room you have to the ground, and how far your toe travels to the lever.
What does the listing state?
| Detail | |
|---|---|
| Price | See the product card |
| Material | T6 aluminium alloy, anodised finish |
| Adjustment | seven holes for footpeg height positioning |
| Pegs | anti-slip design |
| Options | four |
What should you know about seven holes, seven positions?
On the ZONTES 703RR, the listing specifies seven adjustment holes for footpeg height: seven mounting points, each sitting the peg at a different height relative to the frame. What it does not publish is a millimetre figure per hole.
Rearset marketing often quotes up-and-back offsets from stock; we are not going to reproduce numbers that are not on the page. What you can rely on is the count: seven positions, enough range to fit different leg lengths and boot sizes.
What does actually change when you move the peg?
On the ZONTES 703RR, knee and hip angle. Higher pegs fold your leg tighter. Riders with long legs notice this first, usually in traffic. Ground clearance. Higher pegs touch down less. If you have been dragging the standard pegs, this is the change you are buying.
- Lever reach. Move the peg and the distance to the shift and brake levers changes with it. Re-set the levers after the pegs are final, or the bike will feel wrong wherever the peg sits.
What should you know about material and finish?
On the ZONTES 703RR, T6 is a heat-treated aluminium grade chosen for stiffness at low weight. Anodising is a hard surface layer that resists scuffing better than bare or painted aluminium. The anti-slip peg surface is the part you notice on a wet ride, long before you notice the colour.
What do rearsets not do?
On the ZONTES 703RR, they are not crash protection: a rearset is a bracket, and it can bend like any bracket. They do not change front-end geometry, and they come with no performance claim that stands up to scrutiny.
What should you know about installation, four checks?
On the ZONTES 703RR, fit the brackets loosely first, choose the peg position, then tighten. Tightening before the position is settled means doing it twice. Set shift and brake lever heights after the pegs are final. Ride height and lever height are one decision.
- Check the brake light switch operates through the full lever travel before you ride. A rearset that leaves the switch permanently on, or never on, is a safety problem.
- Turn the bars lock to lock and check nothing fouls. Pegs that move up and back live closer to the swingarm and exhaust.
How do you care for the rearsets?
On the ZONTES 703RR, mild soap and a soft brush. Abrasive polish cuts through anodising and leaves a patch that cannot be repaired without stripping the part. Check the fasteners after the first few rides: rearsets take your whole body weight.
What are the common questions?
On the ZONTES 703RR, these are the usual questions. Will seven positions be enough? Do they fit other ZONTES models? Can I keep the standard levers?
Will seven positions be enough?
For most riders, yes. For very long legs or a specific race position, check the bracket shape in the photos.
Do they fit other ZONTES models?
No, listed for the 703RR only.
Can I keep the standard levers?
The set replaces the peg and bracket assembly. Check the photos against your bike if it has been modified.
ZONTES 703RR Adjustable Rearsets. Pair with the triple clamp and clip-ons.