Updated November 2026. Most windshield problems are created during fitting, not by the screen. A screen that is overtightened, or tightened before it is aligned, will crack at a fixing hole within a season. This is the order that avoids it.
What should you check before you start?
Bike cool, out of direct sun. Acrylic and polycarbonate are easier to work with at room temperature and more brittle when cold. Clean the mounting area so grit is not trapped under the screen. Keep the original fasteners and any rubber grommets or well nuts.
- They are part of the design, not packaging.
What order should you follow?
Dry-fit with nothing tightened. Set the screen on the mounts and look along the edges. Hand-start every fastener two turns. All of them, before any of them is tight. Check the gaps at the top edge, around the headlight opening, and at the sides.
- They should be even.
- Tighten in a cross pattern, one turn at a time, until the screen is held without being compressed.
- Re-check the gauge sightline from your normal riding position, not from beside the bike.
What is the torque question?
No manufacturer publishes a torque figure for aftermarket screens, and any article that gives you one is inventing it. What matters is that you stop when the screen stops moving, not when the fastener stops turning. Rubber grommets exist to absorb vibration and allow slight movement.
Compress them fully and you have removed the reason they are there.
Why screens crack at the holes?
Two reasons: over-tightening, and misalignment. If a hole does not meet its fixing, the fastener pulls the screen sideways to reach it, and the material around the hole carries a load it was not designed for. If a hole will not line up, stop.
Check you have the right variant for your model and year, or that the panels beneath are seated correctly. Do not open the hole out.
What should you know about after the first ride?
Check every fastener again. Vibration settles new screens, and what felt tight on the stand can be loose after fifty miles.
How do you clean, briefly?
Plenty of water, mild soap, a soft cloth, and never a dry wipe over grit. Solvents and petrol attack acrylic. Polish only if the product is intended for plastic screens.
What should you know about screens for this job?
- Yamaha XMAX 300 Front Windshield
- CFMOTO 450SR Racing Modified Windshield
- ZXMOTO 820RR Windshield — PC polycarbonate, 2026 820RR only
- CFMOTO 675SR-R Split Racing Windshield
All bolt on at the stock points. The fitting sequence above is the same for each. Screens by platform: 450SR, 675SR-R, 500RR, XMAX 300.
Yamaha XMAX 300 Front Windshield
Front windshield for the Yamaha XMAX 300. Listed in 4 style options.
From $99.00
CFMOTO 450SR Racing Modified Windshield
Racing modified windshield for the CFMOTO 450SR. Listed in Clear, Smoke Gray and Black.
$199.00
Windshield for the ZXMOTO 820RR. Listed in Black and Gray; Ridged or Rounded.
$199.00
CFMOTO 675SR-R Split Racing Windshield
Split racing windshield for the CFMOTO 675SR-R. Listed in 8 colors.
From $269.00
| Dimension | Notes |
|---|---|
| Platform | Not a single-bike fitment note. Confirm the platform on the product page. |
| Part | This guide |
| Install | Not a single-part install note. Follow the sections above. |
| Use | Care, fit, or buying judgment. Not a fitment claim for one bike. |
| Shop | https://isleparts.com/products/yamaha-xmax-front-windshield |



