Updated November 2026. The ZXMOTO 820RR exhaust hanger is the cheapest structural part in the range — it supports the canister at the engine-side mounting point, which makes it a part with a job, not a styling accessory.

In short:
- One of the two cheapest parts in the 820RR range.
- It carries the canister — a failed hanger moves the exhaust into panels and paint.
- Shares space with the raised footpegs; check them together.
What does the exhaust hanger change?
On the ZXMOTO 820RR, an exhaust hanger carries the canister's weight and takes heat and vibration. If the hanger fails or is missing, the exhaust moves — and a moving canister chases panels, boots and paint. This listing supports the stock-position canister; it is not an accessory bracket for aftermarket systems.
What is the clearance it shares?
On the ZXMOTO 820RR, on the right side of the bike, the hanger, the raised footpegs and your boot share the same space. If you are ordering both — the two most common 820RR companions — check them together: peg bracket position against hanger position, with your boot in the picture.
| Part | Where to check the price | Shares the right flank with |
|---|---|---|
| Exhaust hanger | See the product card | footpegs, boot, canister |
| Raised footpegs | See the product card | hanger, boot |
| Fuel cap grip pad | See the product card | nothing — tank top |
What else buys here?
Only one other part in the ZXMOTO 820RR range sits: thefuel cap grip pad. One is structural, one is a non-slip detail — if you are choosing between them, the hanger is the part that can fail.
How do you install the exhaust hanger?
- Support the canister before removing the old hanger; an unsupported exhaust pulls on its header.
- Torque the mount to your manual's figure and recheck after the first ride — this part takes load and heat.
- Aftermarket, not official ZXMOTO; confirm the model year on the listing.
On the ZXMOTO 820RR, a hanger refitted with the canister hanging loose is how exhaust gaskets fail. Ten minutes with a strap under the canister avoids the whole problem.
What are the common questions about exhaust hanger?
On the ZXMOTO 820RR, these are the usual questions. Does it fit aftermarket exhausts? Is it carbon? Why is a hanger only? Are these genuine ZXMOTO parts? Do I need to remove the rear wheel?
Does it fit aftermarket exhausts?
The listing supports the stock canister position. Aftermarket systems vary — check the hanger's shape against your canister before ordering.
Is it carbon?
No — the 820RR range has no carbon. It is listed without a carbon claim, unlike the ZX-10R and S1000RR ranges.
Why is a hanger only?
Small part, single mould, one job. Price tracks tooling and size, not importance.
Are these genuine ZXMOTO parts?
No, aftermarket, as the listing states.
Do I need to remove the rear wheel?
No. The hanger mounts at the engine-side point and is accessible without removing the wheel.
Product page: ZXMOTO 820RR Exhaust Hanger. Collection: ZXMOTO 820RR parts.