Updated November 2026. Winter does not damage bodywork. Storage mistakes do. Dirt left on a panel holds moisture, a screen stacked under something takes a set, and a carbon part stored in sunlight yellows its clear coat. None of that happens in a season of correct storage, which takes one afternoon.

How do you choose: panels on or off?
Leave them on if the bike sleeps in a dry garage and the panels are sound. Clean them properly before storage, check that no fastener is loose, and the bike can sit as it is.
Take them off if three things are true: the originals are coming off anyway for winter maintenance, the storage space is shared or damp, or you are keeping stock panels in a box alongside carbon ones. Off means every panel gets cleaned, inspected and stored on its own terms — and it is the moment to replace tired clips so spring fitting starts with new ones.
Both are correct. What is not correct is pulling panels off in December, stacking them in a corner, and calling it storage.

How do you clean before storage, properly?
Rinse, then wash with pH-neutral shampoo — the same routine as screen cleaning, applied to every panel. Dry fully. Water sitting in a panel gap for three months starts corrosion on fasteners and haze under clear coat. Inspect while drying: white clips, cracks at holes, marks behind panels — the annual check, done in November instead of spring.
- Wax gloss paint if the panel is painted. Do not wax matte, and do not wax carbon — a sealant at most.
How do you store loose panels?
Flat or on its natural curve, never standing on an edge. A panel that takes a set in storage will not sit flush in spring. Wrap in cotton or a soft cloth, not sealed plastic. Sealed plastic traps condensation against the finish for months.
- Breathable is the rule; the original box with the lid off works.
- Dark and temperature-stable. Direct sun yellows clear coat over time, and a garage that swings from freezing to mild stresses films and edges. An indoor closet beats an outdoor shed.
- No stacking. One panel per layer, soft separator between. Weight on a screen or cowl edge is how takes-sets happen.
- Fasteners in labelled bags taped to the panel they came from. Spring you will not remember which bolt went where — the fastener rules still apply at reassembly.

What should you know about screens, specifically?
Acrylic and polycarbonate screens store clean, dry and flat, away from solvents and fuel vapour — petrol fumes haze plastic in an enclosed box over a season. Do not leave a screen in a heated space that swings hard; do not leave it under anything.
If it stored on the bike, a soft cotton cover over the screen beats a tight plastic one.
What should you know about carbon, specifically?
The real carbon rangesZX-10R and S1000RR — store like paint with two extras: keep them out of prolonged direct sun even indoors, and keep fuel cans and solvent tins well away, because vapour dulls clear coat in enclosed spaces over months.
Carbon-look films add one rule: nothing abrasive stored against them, because the film edge lifts first.
What is the spring return?
Wipe panels down, inspect the edges you stored. Fit with fresh or verified clips, hand-starting every fastener — the alignment sequence, unchanged by the season. Re-torque after the first ride, because a winter off means every grommet is starting fresh too.

| Dimension | Notes |
|---|---|
| Platform | Not a single-bike fitment note. Confirm the platform on the product page. |
| Part | This guide |
| Install | Not a single-part install note. Follow the sections above. |
| Use | Care, fit, or buying judgment. Not a fitment claim for one bike. |
| Shop | https://isleparts.com/collections |
What are the common questions about storage?
Can I store panels in the original bubble wrap? Is a cold garage fine? Should I oil the fasteners before storage? Can carbon panels touch each other in storage? What should you know about the bike cover?
Can I store panels in the original bubble wrap?
Only loosely, and only if they are perfectly dry. Sealed wrap against a finish for months invites condensation marking. Cloth is safer.
Is a cold garage fine?
Cold alone does not hurt stored panels — force applied to cold panels does, which is a spring fitting issue. Dark and dry matter more than warm.
Should I oil the fasteners before storage?
A wipe of oil on exposed steel bolts helps in damp garages. Anti-seize on aluminium threads is the better habit.
Can carbon panels touch each other in storage?
With a soft separator, yes. Bare carbon on carbon chips edges.
What should you know about the bike cover?
Breathable covers only. A plastic tarp over a damp bike is a haze kit.
Care reading: carbon care · products that damage panels.